Sound
Water eject sound
A low tone from the water eject page plays through the phone speaker and may help loosen water around the speaker grille.
Water vibration · Water eject iPhone · Remove water from speaker
Play the tone
Ready
A short tone may help loosen water in your speaker grille. You may hear a clearer sound.
Unplug headphones, chargers, and other accessories before you start.
Keep a wet phone off the charger, and off a computer, until it has had time to dry.
Keep the volume comfortable. The volume cannot reach full speaker output.
Press Start to play. Press Stop to end it immediately. The volume cannot reach full speaker output.
Results vary by device. If your speaker stays muffled, let the phone dry fully and see our wet phone guide.
What you may hear
The water eject sound may come through as a low sweep, and it can differ from one phone and speaker to another. Crackle or distortion may be audible. Press Stop if the tone is uncomfortable or unusually harsh. Hearing it does not mean water has come out.
How to keep the sound on the phone
Unplug headphones and chargers, turn Bluetooth off, and set the speaker face down on a dry, soft surface. Press Start, then press Stop when you are finished. A sound to get water out of phone here means that short grille tone only. If the phone was submerged, follow the wet-phone guide and keep it off the charger.
Water tone and dust tone
The player has two modes. The water tone, labeled Water Eject, is the lower-frequency sound. Dust / Speaker Clean is the higher-frequency speaker dust cleaning sound, meant for dust around the grille. Neither mode washes the phone, repairs the speaker, or guarantees that water or dust will leave.
What this sound cannot do
It cannot dry the battery, the charging port, or the inside of the phone. It cannot guarantee that water will leave, and it cannot repair speaker damage or corrosion. Do not use heat, compressed air, or rice, and do not push an object into an opening. Never charge a wet phone.
When to see a technician
Have a technician inspect the phone if it stays wet, feels warm, or the speaker stays quiet or distorted after it has had time to dry. The phone speaker guide covers the steps around the grille, and this page does not repeat them.
Questions
What is a water eject sound?
It is a low tone played through the phone speaker. The speaker may move, and that movement may help loosen water sitting in the grille. You may hear a clearer sound afterward.
Can the tone dry the whole phone?
No. The tone only reaches the speaker grille. Let the inside of the phone dry in open air, and keep it off the charger while it is wet.
How loud should I play it?
Loud enough to hear clearly, and no louder than feels comfortable. Press Stop if the tone is harsh. The volume control cannot reach full speaker output.
What if the speaker still crackles?
Stop the tone and let the phone dry. If the speaker stays quiet or distorted after it has had time to dry, have a technician check it.